Desolate Motorsports Level 1 TTB


These modified beams will fix your camber and addresses other issues if you’ve lifted your vehicle over 3 inches.

Note: A $500 core charge for beams is required for any customers who are not supplying a cores. After purchase a Desolate Motorsports representative will reach out regarding questions about your set up and for Core charge payment or shipping instructions for cores. 


Our Level 1 beams are modified in house to correct the wheel camber. This modification will work for lifts from 3-4″. Correcting the camber is important to maintain proper tire wear and get the best performance out of your steering configuration. In addition to camber correction, we address issues where the axle shaft can come in contact with the passenger side beam housing while fully articulated. Lastly, we weld on reinforcement plating to the passenger beam, where we commonly see failures and bending. This is our standard beam that any of our 4″ coil spring suspension kits receive.

Note: Order any Beam Package and Radius Arms at the same time and we will weld on radius arm mounts in house at no extra charge. Photo shown with radius arm brackets welded on. All modified beams ship raw metal and come with new pivot bushings (not installed) 


  • Corrects camber on raised Broncos and 4×4 F150s
  • Properly clears passenger axle shaft in full articulation
  • Added gussets for strength

What’s Included:

  • Drivers Side Beam (1)
  • Passenger Side Beam (1)
  • New Pivot Bushing (Pair)

Additional information

Weight 51 lbs
Dimensions 44 × 14 × 11 in
Vehicle Make

80-96 4×4 F150, 80-96 Bronco