5/8” Stud and Lug Nut Combo for Front Dana44


This combination of wheel studs and lug nuts are everything you need to convert your front end to 5/8” studs.


Bigger is always better. This kit is intended for Dana44 TTB. They have 3/4″ long knurling to properly presses fully into hubs and rotors. These 5/8” heavier duty wheel studs hold up to abuse better and will give you piece of mind while wheeling. These are easily fitted to stock hubs and rotor with minor drilling and pressing. Our 5/8-18 lug nuts are zinc coated and machined with a 60-degree conical seat for aftermarket non-beadlock wheels and machined down to allow large studs and full floating hubs without modification to wheels. These 5/8” studs and lug nuts are a great upgrade for anyone who has increased tire size to 35” or larger and are what we use on all our Bronco front ends as well as other vehicles here at the shop.


  • 1″ Diameter hex.
  • Zinc coated nuts.
  • Same style stud is used on Trophy Trucks.
  • Half inch lug nut guide to prevent cross threading.
  • Tougher than factory studs.

What’s Included:

  • 5/8” Wheel Studs (10)
  • 5/8” Lug Nuts (10)
  • 21/32mm Drill Bit

Additional information

Weight 8 lbs
Dimensions 6 × 6 × 6 in